DC Buyer's Guide

Accessories and Modifications CD180AT through CD6900

ITEM

DESCRIPTION

7 BEARINGS (Belted Drive) Standard shaft for frames CD180AT-CD6100 are suitable for either belt drive or direct coupling within the limits given in the application section on page 5.5. Frames CD6200-CD6900 are suitable for direct drive only. Where the maximum radial load at the end of the shaft exceeds the standard limits, oversize ball bearings and roller bearings are available as listed below. Maximum radial loads and speeds for these modifications are given on pages 5.8 – 5.9.

Modifications Motor Pricing General Information

OVERSIZE BALL BEARING ON DE*

STANDARD SIZE ROLLER BEARING ON DE OVERSIZE ROLLER BEARING ON DE*

CD218-CD2110

Add $366 CD287AT, CD288AT

Add $1044 CD287AT, CD288AT

Add $1210

CD258-CD288

$468 CD327AT, CD328AT, CD329AT

$1044 CD327AT, CD328AT, CD329AT

$1210

CD327-CD328

$574 CD365AT-CD508AT

$1732 CD365AT-CD5010AY

$2498

CD365-CDL407

$680 CD6000 (Top spd. 1750 RPM)

$3334 Not available on frames

CD180AT, CD210AT, CD258AT, CD259AT, CD6000-CD6900

CD409-CDL409

$766 CD6100 (Top spd. 1500RPM)

$3860

CD504-CDL508

$892 Not Available on frames

CD180AT, CD210AT, CD258AT, CD259AT, CD5010AY, CD6200, CD6700, CD6800, CD6900

* When an oversize bearing on DE is specified, a standard DE shaft extension will be furnished. However, if also required an oversize DE shaft is available at no additional price.

8 BRAKES — Refer to Wolong for application of brakes rated above 100% of rated motor torque. Order must specify AC/DC voltage and frequency, torque rating (Lb. Ft.), enclosure, and orientation with respect to the motor. Customer is responsible for specifying brake torque rating. We do not recommend the use of brakes on TEFC Kinamatic motors. When brakes are required, we recommend TEAO enclosures. 8a BRAKES, DISC TYPE These brakes are applicable for holding service within rating limitations shown in the table on the next page. Where brakes are required for stopping duty, the heat-dissipating capacity may be the determining factor in the brake selection. Refer to Wolong . Brakes are continuously rated and are nonadjustable spring set and electrically released. For brakes of a specific manufacturer, nonlisted capacity, or adjustable or electrically set brakes, refer to Wolong . For frames CD6000-CD6900, use floor-mounted brakes.

Accessories and

Information Outline Dimensions

Disc type brakes — Disc type brakes are commonly used on ratings 250 HP and below. The brakes are continuously rated and can be mounted on CD180AT CD5010AY frames.

Application

AC brakes are recommended on disc brake applications wherever possible, especially for those applications where high cycling duty may occur (e.g., on hoist or screw-down applications). Use a brake of standard enclosure with dripproof fully guarded or splashproof fully guarded motors, and on TENV and TEAO motors for applications in ambients containing chips and/or non-abrasive, non-conducting, and non-explosive dusts and coolants.

Other Information

3.4

www.wolongamerica.com

GEP387-EN 07/19 Prices and data subject to change without notice.