DC Buyer's Guide

Accessories and Modifications CD180AT through CD6900

ITEM

DESCRIPTION

14 CUSTOMER-SUPPLIED MATERIAL No testing is performed and no warranty is provided for customer-supplied material. All customer-supplied material must be sent to the following.

Modifications Motor Pricing General Information

Monterrey L&M/GE Industrial Motors 605 NAFTA Blvd Milo Distribution Center Laredo, Texas 78045 Attn: Customer Service

14a BRAKE WHEEL Customer-supplied DS brake wheels must be completely machined and dynamically balanced prior to receipt at the factory. The factory cannot rebalance the motor after assembly of customer-supplied brake wheel. Add $3192 list per motor. This price addition is for mounting a brake wheel on the commutator end shaft extension only. Contact Wolong for mounting any other brake components or assemblies to the motor. Note: Refer to Wolong for application of brakes rated above 100% of rated motor torque. Mounting/installation instructions, outline dimensions, and parts list must be received at the time of order. Brake wheel must be received at the factory a minimum of 3 weeks prior to promised ship date. Brake wheel mounting on frames CDL182AT-CD5010AY requires a commutator end shaft extension adder. Refer to page 3.19, Item 24. No adder required for Comm End Shaft Extension on CD6000-CD6900 frames. 14b COUPLINGS (Customer to supply installation instructions for coupling to Wolong ) For mounting a coupling (which must be completely machined and balanced prior to receipt at the factory), WITH finish bore and keyseat, add $3192 list per motor. The factory cannot rebalance the motor after assembly of customer-supplied coupling. Finish bored and key seated coupling and outline drawings must be received at the factory a minimum of 3 weeks prior to promised ship date. For mounting a coupling (which must be balanced prior to receipt at the factory), WITHOUT finish bore and keyseat, add $6932 list per motor. Unfinished coupling and outline drawings must be received at the factory a minimum of 4 weeks prior to promised ship date. 14c TACHOMETER GENERATOR EQUIPMENT Customer-supplied tachometers will not be tested. Drawings, installation instructions and parts list of customer supplied tachometers must be received at the factory a minimum of 3 weeks prior to promised ship date. For pricing, refer to page 3.29, Item 29c. 14d PAINT Due to hazardous waste disposal regulations and VOC emissions requirements, Wolong will not accept orders using customer-supplied paint. For special paint requirements needed to meet application and commercial needs, contact Wolong. 15 DRAINS Drain holes are normally selected to provide drainage of moisture that might collect at the lowest point of the motor. Not available on CD180AT Frames. When drain holes are required, placement for horizontal and vertical mount are as follows: Horizontal Mount (1) at each end, vertical CD210AT-CD320AT: (3) at lowest point, CD360AT and above: (1) at lowest point. 15a TAPPED HOLE, add $430 list per motor. No adder required for Waterproof enclosures. 15b TAPPED HOLE WITH SOLID PLUG, add $430 list per motor. No adder required for Waterproof enclosures. 15c AUTOMATIC DRAIN BREATHER, add $510 list per motor. Available on totally enclosed CD210AT-CD5010AY frames only. Not available on CD6000 frames.

Accessories and

Information Outline Dimensions

Application

Other Information

3.12

www.wolongamerica.com

GEP387-EN 07/19 Prices and data subject to change without notice.