DC Buyer's Guide

Accessories and Modifications CD180AT through CD6900

ITEM

DESCRIPTION

32 TEMPERATURE DETECTORS A bimetallic temperature-sensing device is mounted on the commutating coil. The device is available with normally open or normally closed contactors. Specify whether normally open or normally closed contacts are required. (Included as standard on TEUC motors). Thermostats are typically normally closed and the opening temperature is between 120° C to 150°C. Thermostats with special temperature rating are non-standard. Refer to Wolong when required.

Motor Pricing General Information

Maximum Current Ratings (Normally open or normally closed contacts)

Load 125V AC 250V AC Resistive 5 Amps 2.5 Amps

600V AC

30V DC 5 Amps

Thermostat ratings for DPFG and TE motors (standard on TEAAC, TEWAC and explosionproof motors)

1 Amp

0.5 Amp (Do not use above 600V AC)

1.5 Amps (Do not use above 30V DC)

Inductive* 3 Amps 1.5 Amps

* Suitable for pilot duty only (relay coils)

For the following types of temperature detectors mounted in the locations indicated, see below for pricing. Price does not include electronic sensor module.

LOCATION

TEMPERATURE DETECTORS

Bearing

Commutator Field or Shunt Field

List Price Addition

a. Thermostats

Not Available Not Available

$310 $450

b. Thermistors (PTC Type)

Other Information Application Information Outline Dimensions Accessories and Modifications

c. Resistance Temperature Detectors (RTD) Copper - 10 Ohm

$2266 $4532 $2266 $2266

$900

Platinum - 100 Ohm Nickel - 120 Ohm

$1800

$900

d. Thermocouples (Type J)

Not Available

33 VERTICAL MOUNTING (FOOTED) The following applies to vertically-operated foot- or flange-mounted, standard ball bearing, motors where no external thrust is reflected back to the motor shaft . Refer to Wolong for external thrust limitations. For vertical brake applications, refer to Modification Item 8a. Note: For crane motors, refer to page 3.11, Item 13. All drip - proof and splash - proof motors which are mounted vertically require non-standard covers (the louvers are rotated to provide protection in the vertical position). Totally enclosed motors require no modifications to the covers. Frames CD180AT-CD320AT do not require internal modification for vertical mounting. Thus, a standard motor in these frame sizes is suitable for vertical mounting. Frames CD360AT-CD6900 require internal modification for vertical mounting. Thus, a standard motor in these frame sizes is not suitable for vertical mounting. The CD365AT-CD5010AY frames require shaft seals for vertical mounting with the shaft down. The CD365AT-CD5010AY frames mounted shaft up require additional modifications to the bearings and shaft . Refer to Wolong for applications involving vertical mounting of CD6000-CD6900 frames.

List Price Addition CD365AT-CD5010AY

Enclosure

CD180AT-CD320AT

CD6000-CD6900

DP

Add 2%

Add 2% + $596 Add 2% + $596* Add 2% + $1050 Add 2% + $1050

Vertical Shaft Down

TE

No Price Addition*

Refer to Wolong

DP

Add 2%

Vertical Shaft Up

TE

No Price Addition

Notes:

DP Dripproof TE Totally Enclosed * If TEFC waterproof, contact Wolong For CD180AT, will not meet NEMA definition for DPFG, the motor is considered “fully guarded”. (Refer to page 3.16, Item 17 for C-Face and D-Flange pricing.)

3.31

www.gemotorswolong.com GEP387-EN 07/19 Prices and data subject to change without notice.